---

---

 

 

 

Re-install the skull pile to make sure bulbs are nicely covering the flame holes. If not, you may
need to re-drill and re-align. On my right one, it was too high. The good news? If you're
just a little off....the skull pile can be angled a tad when you screw it into place.

I was very pleased at this step in the process. In fact, this was the original intent and stopping point.
However, the bulbs shined through the acetate too much. They became very distracting and
over- powering. I doubled up the yellow on each flame. It did not "dull" the bulb much.

You may, however, like the look at this point in the process. If so....I say leave it alone. However, I
took it a step further and inserted orange bulb covers (step 7). Boy is it cool.

 

---

<<- Back

---