---

---

 

 

 

Re-attach the skull pile and "line-up" where the bulbs will eventually go. Mark the backboard where the
middle of the bulb should end up. Then remove the skull pile, align the bulb socket and mark the
drilling spot. You need to mount the bulb vertically, so some shaping of the socket may
be required.

I secured the yellow acetate in place with double-sided tape. It worked well. However, this was just
temporary until the JB Weld epoxy finished settling. If your epoxy is ready, go ahead and attach
the acetate to the pile.

 

 

---

<<- Back

---